Pool Winterizing Instructions for Central Texas Climate
The summer swimming season is coming to a close, and it’s time to start getting your pool ready for the cold winter months. Properly winterizing your pool will save time and money when you are ready to start swimming again in the spring. Since you live in a climate where the temperature rarely dips below freezing in the winter, you can continue circulating the pool water using your pump and filter. When you cover your pool, you can reduce the amount of time your pump runs and the amount of chemicals that you need to add to the pool.
A good time to begin the winterizing process is in the fall, just as the colors change, but before the leaves have a chance to fall into your pool.
A chemical treatment to your pool is essential. A combination of proper water balance, an oxidizing agent, a stain preventer and a concentrated non-metallic algaecide will insure that your pool stays clean over the winter and is ready for use in the spring when the warmer weather arrives. Many manufacturers supply ready-made, winterizing kits that contain the chemicals mentioned above. Each manufacturer has different directions so make sure you follow the exact directions on your winterizing kit. Essentially, these chemicals will put extremely high levels of chlorine, alkaline, and algaecide in the water to prepare for the winter months ahead. Some of these chemicals mandate that the pool filter be turned on while the chemicals are added. Make certain you follow this direction.
Chlorine 2.0-3.0ppm
pH 7.2-7.4ppm
Total Alkalinity 100-120ppm
Calcium Hardness 200-400ppm
Cyanuric Acid (Chlorine) 30-50ppm
Cyanuric Acid (Salt) 50-80ppm
1) Make sure the pool is clean and clear, and the water is in balance:
Brush and vacuum the pool thoroughly to remove all dirt, leaves and debris.
Make sure the skimmer baskets, pump basket, and filter is clean.
Backwash or clean filter if needed.
2) Make sure the water level is at or above proper level
3) With the pump running, add:
a. 1 qt. Sequa-Sol
b. 4 lbs. Shoxidizer
c. 1 qt. Algimycin 600
per 20,000 gallons.
4) Fill floating chlorine dispenser with GLB slow dissolving 3” chlorine tablets and set on medium to low output setting.
Once the chemicals have been added, you can go ahead and cover the pool. Make sure that the cover is at least 5’ longer and 5’ wider than the longest and widest points of the pool. Before stretching the cover across the pool, you should install a floatation device in the center of the pool. This device can be a large inflatable winter pillow designed for this very purpose. The float serves two functions. First, it balances the rainwater and ice sure to form on your pool’s cover over the winter. Secondly, The area around the float will not freeze over the winter and will allow the ice to push inward toward the float, rather than outward towards the pool wall. This will ease the tension on the pool walls and tile.
5) Let the pump run for six to eight hours for proper chemical distribution in the water.
6) Change the run times on your timer box or controller for your main pump to run 3-6 hours during the middle of the night, set run times for booster pump operated pool cleaners to run 1 hour during the main pump run time. Make sure your freeze protector is operating properly to keep the water circulating during potential freezes. Having a Freeze Protector installed will be beneficial for the well-being of your pool, pool equipment, plumbing, valves as well as provide peace of mind during the winter months, even in Texas.
Now that your pool is covered for winter, some maintenance may be necessary to extend the life of your cover and ensure a clean, clear opening in the spring.
-Keep the cover clear of debris and excess water.
-A small amount of water (about 1/8?) left on the cover will help keep the cover flat against the water’s surface and prevent the wind from lifting up the cover.
Need a pool freeze guard?
-If the pool is covered with a mesh cover or leaf net, the water level and chemical balance should be monitored on a regular basis (usually once a month). Depending on local precipitation, the water level and chemical balance may need to be adjusted to prevent algae, staining and scaling.
Come see us at One Stop Pool & Spa in Plano, TX (NE corner of W. Spring Creek Pkwy and Custer Road) for the best prices in pool chemicals and covers. We also have the best prices on new pool equipment, replacement parts, and all of your pool and spa supplies. We will be happy to answer any other questions you may have. Or visit us on-line at www.1StopPoolStore.Com.
